Table Allowable surface stress (MPa) for a 3seconds duration load according to ASTM E . The 3seconds duration load that represents the. New Provisions in ASTM e‐ A comparison of the Basic and New Analytical Procedures for Determining the. Load Resistance of. for glass strength, ASTM E , “Standard Practice for Determining the Minimum Thickness and Type of Glass. Required to Resist a Specified Load” which.
|Published (Last):||17 February 2004|
|PDF File Size:||18.8 Mb|
|ePub File Size:||4.22 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM E1300 Wind Load Calculator
Skip navigation Skip to section menu Skip to page menu. Head Office – Mita Minato-ku Tokyo.
Click Here to Begin Link to Active This link will always route to the current Active version of the standard. Glass must be selected and designed to conform with applicable Safety and Building Code Requirements. Determination and Report of Procedures.
This practice assumes that 1 the supported glass edges for two, three and four sided support conditions are simply supported and free to slip in plane 2 glass supported on two sides acts as a simply supported beam, and 3 glass supported on one side acts as a cantilever. Maximum glass deflection and edge pullout under the design load should always be considered.
Nippon Sheet Glass Co.
ASTM E – 04 Standard Practice for Determining Load Resistance of Glass in Buildings
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. It is the responsibility of the user of e3100-04 standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
For more information about, or to purchase a copy of, the complete program, call Standards Design Group toll-free at or visit their web site at: This practice shall not apply to other applications including, but not limited to, balustrades, glass floor panels, aquariums, structural glass members and glass shelves.
If the application does not appear within a few seconds generally less than 30 seconds under e13000-04 conditionsyou may need to download the plug-in by clicking here.
Wind Load Calculator
Work Item s – proposed revisions of this standard. The final thickness and type of glass selected also depends upon a variety of other factors see 5. This calculator makes it easy for you to perform preliminary assessments of the Wind Load resistance of single glazed, annealed not heat treated window glass, with e1300-0 edge support conditions, according to the ASTM E standard.
Appendix X3 presents a procedure to compute approximate probability of breakage for annealed monolithic glass lites simply supported on four sides. Active view current version of standard.
D Practice for Plastics: The values given in parentheses are for information only. For conversion of quantities in various systems of measurements to SI units refer to SI Appendix X1 and Appendix X2 provide additional procedures to determine maximum lateral deflection for glass simply supported on four sides.