Trademarks: “ICC,” the International Code Council logo and “Accessible and Usable Buildings and Facilities (ICC/ANSI Al )” are trademarks of the. This Accessible and Usable Buildings and Facilities (ICC Al) is a The edition of ANSI Standard A presented the first criteria for accessibil. Major changes/additions from ICC ANSI A – found in the edition of A 1. ICC ANSI. A – Section. ICC ANSI A –
|Published (Last):||1 September 2004|
|PDF File Size:||4.50 Mb|
|ePub File Size:||20.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
Top of gripping surfaces of handrails shall be 34 inches mm minimum and 38 inches mm maximum vertically above stair nosings, ramp surfaces and walking surfaces. Showers shall deliver water that is degrees F 49 degrees C maxi- a117.1-22003. The height of bathtub seats shall be 17 inches mm minimum to 19 inches mm maximum above the bathroom floor, measured to the top of the seat.
State Building Code – ICC/ANSI A Code Interpretations
Building Blocks Chapter 3. Emergency controls shall comply with Section Sliding or folding door: Clear floor spaces, clearances at fixtures, and turning spaces shall be permitted to overlap.
Inthe U. Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from ver- tical.
2003 ICC Accessible and Usable Buildings and Facilities
In standard roll-in showers with seats, the controls and hand shower shall be located on the back wall, no more than 27 inches mm maximum from the end wall behind q117.1-2003 seat.
You may delete a document from your Alert Profile at any time. Where located in the side wall or partition, the door opening shall be 4 inches mm maxi- mum from the front partition.
Communication Elements and Features General Accessible Routes inches mm above the jcc.
ANSI A117.1 (2003): Accessible and Usable Buildings and Facilities
Unless specifically stated, figures included herein are provided for informational pur- poses only and are not considered part of the standard. A117.1-2030 an acoustic cou- pler is used, the telephone cord shall be of sufficient length to allow connection of the TTY and the tele- phone handset. Knee and toe clear- ance complying with Section shall be provided.
A hand shower icx a hose 59 inches mm minimum in length, that can be used both as a fixed shower head and as a hand shower, shall be provided.
In addition, it does not contain requirements necessary for conformance to the standard. Stair treads shall comply with Section and shall have a slope not steeper than 1: For bathtubs with permanent seats, grab bars com- plying with Section The lead- ing edge of such guardrail or barrier shall be 27 inches mm maximum above the floor. Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards.
The verbal annun- ciator shall have a frequency of Hz min- imum to 3, Hz maximum. Controls shall comply with Sec- tion The running slope of walking surfaces shall not be steeper than 1: Counter slopes of adjoining gutters and road surfaces immediately adjacent to the curb ramp shall not be steeper than 1: Accessible Routes tion Operable parts shall comply with Section Where detectable warnings are provided on curb ramps or at raised marked crossings leading to islands or cut-through medi- ans, the island or cut-through median shall also be provided with detectable warnings complying with Sectionare 24 inches mm in depth, and extend the full width of the pedestrian route or cut-through.
Table of Contents | ICC/ANSI A – | ICC premiumACCESS
If provided, occu- pancy-sensing automatic controls shall activate the stairway lighting so the luminance level required by Section Allowable stresses shall not be exceeded for materials used where a vertical or horizontal force of pounds 1 1 12 N is applied at any point on the seat, fastener mount- ing device, or supporting structure.
In alternate roll-in showers, the controls and hand shower shall be located 38 inches mm minimum and 48 inches mm maximum above the showerfloor.
Each destina- tion-oriented elevator in a bank of elevators shall have audible and visible means for differ- entiation. Each arm of the T shall be clear of obstructions 12 inches mm minimum in each direction, and the base shall be clear of obstructions 24 inches mm minimum. At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal dis- a1171.-2003 equal to one tread depth beyond the bot- tom tread nosing.